I need something small to put the Intel d945gclf2 motherboard inside and i came up with this super cheap case..
I need something just fit the board and after few hours, it ended up with this…

As you can see the image above, i removed the fan because i want to put the 120×120mm fan later. I drilled 4 holes and mounted the stands. I then put the board on these stands and tighten it with 4 screws. If you do it right, it should be Ok to put it verticle.

I can close it and flip it without worry the board might drop on the floor…

Next, i drilled 4 holes and mount the disk. the screws are under the disk in this image.

And last thing, the fan mounted on the top, just remember to make the hole!!